Lp Conversion Instructions - Travis Industries DVL EmberGlo GSR2 Insert Owner's Manual

Optional Equipment

LP Conversion Instructions

CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding
with the conversion.
This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority having
jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion, or
production of carbon monoxide may result causing property damage, personal injury or loss of life.
The qualified service agency is responsible for the proper installation of this kit. The installation is
not proper and complete until the operation of the converted appliance is checked as specified in
the manufacturer's instructions supplied with the kit.
Packing List
LP Front Burner Orifice: #56
Convert the appliance prior to installing the gas line to ensure proper gas use.
The GSR Stepper Motor Kit (4-pack = 94400999), (single = 250-01463) is required for converting
this appliance to LP. The kit contains the stepper motor (regulator) and Torx wrench.
1. Access the firebox.
2. Remove the burner.
3. When using LP, remove and discard the two existing orifice gaskets (see below).
© Travis Industries
(
for qualified installers only)
WARNING
LP Rear Burner Orifice: #C55
9/17/2020 - 1536
LP Pilot Orifice
DVL EG GSR2
49