Log Set Installation - Travis Industries DVL EmberGlo GSR2 Insert Owner's Manual

60 Optional Equipment

Log Set Installation

The logs are fragile, especially after exposure to heat.
NOTE : The insert should be in place, with the gas line and vent attached and the firebacks installed (see
owner's manual for further details).
1. Place the rear log as shown below. The two slots on the bottom of the log sit over the pin on the
burner. With the rear log in place, push it all the way back
2. Place the left log on the lower front portion of the burner. The notch on the bottom left of the log rests
on the grate. Push the log backward until it is in contact with the sloped area between the front and
rear burner.
NOTE : Make sure the log does not obstruct any burner holes.
© Travis Industries
(
for qualified installers only)
9/17/2020 - 1536
Bottom View of Log
DVL EG GSR2