Exhaust Restrictor Settings - Travis Industries DVL EmberGlo GSR2 Insert Owner's Manual

Installation (for qualified installers only)

Exhaust Restrictor Settings

Use a 1/4" nut driver to loosen
the screws that secure the baffle
to the top of the firebox. Slide
the baffle slightly forward until
the screw heads are in line with
the keyhole slots . Lower the
baffle and remove from the
firebox. (Re-install baffle after
the restrictor has been
adjusted).
Slide the restrictor to the correct position (consult the vent
chart to the right to determine the proper setting for your
installation). The screw location indicates the restrictor
position.
(stock) Position # 1
Position # 2
Position # 3
Position # 4
Position # 5
Back of Firebox
Loosen the 2 screws on the exhaust restrictor. Slide
the restrictor to the correct restrictor position then
tighten the screws to secure the restrictor. In this
illustration, the restrictor in position 2.
In this example, the restrictor is set in the #3 position.
Tighten the screws to secure the restrictor.
© Travis Industries
1/4" Nutdriver
9/17/2020 - 1536
Position #5
Position #4
Position #3
Position #2
Position #1
(Stock)
DVL EG GSR2
15
40 Feet
(max.)
35 Feet
30 Feet
25 Feet
20 Feet
16 Feet (Min.)
15 Feet
10 Feet
5 Feet
0 Feet