18
Vent Attachment – Tight Installations
The vent connector is shipped attached to the insert but must be removed to facilitate tight
installations. See the directions below for installation.
Locate the screw in the top-center of the front of the insert. Use a ¼" nut driver to remove the
screw and slide the connector toward the back of the insert to disengage the connector from the
top of the insert.
Remove Screw
1/4" Nutdriver
Stretch the liners to their full length. Attach the flex liners to the cap (secure with screws). Route
the flex vent through the chimney from above.
© Travis Industries
Installation (for qualified installers only)
9/17/2020 - 1536
DVL EG GSR2