Command And Response Table Overview - Extron electronics XTP II CrossPoint Series User Manual

Command and Response Table Overview

The SIS command and response tables list the commands sent to a device, the responses
returned to the host, a description of the command function or results executing the
command, and some examples of commands in ASCII.
NOTE: Uppercase and lowercase text are interchangeable unless otherwise stated.
Commands are available for the following functions:
•
•
•
•
•
•
•
•
•
The command and response tables throughout this guide use symbols, which represent
variables in the command and response fields. Command and response examples are
shown throughout the tables. The SIS commands are not case sensitive, except for audio
input gain and attenuation commands.
The ASCII to HEX conversion table below is for use with the command and response table.
Space
Symbol definitions
E
Special Characters
The matrix switcher does not accept the following characters for names or passwords:
+ - , @ = ' [ ] { } < > ` " ; : | \ ?
Ties (see page 50)
Presets (see page 51)
Mutes (see page 51)
Audio Configuration and
Adjustment
(see page 52)
SDI Audio (see page 53)
HDMI Input Settings (see page 54)
VGA Input Configuration and
Adjustment (see page 54)
Scaler Adjustment (see page 55)
HDCP Status (see page 55)
ASCII to Hex Conversion Table
= Carriage return and line feed
]
= Carriage return with no line feed
}
| = Pipe (can be used interchangeably with the
• = Space
= Escape key
= Can be used interchangeably with the
W
• Signal Status
• XTP Setup Parameters
XTP Relay Control
•
• View and Erase File Directory
(see page 58)
• Information Requests
• Lockout modes
Resets
•
• IP and Remote Port Commands
(see page 62)
•
}
E
character.
• (space character, acceptable for names)
XTP II CrossPoint Series • SIS Configuration and Control
(see page 56)
(see page 57)
(see page 58)
(see page 59)
(see page 61)
(see page 61)
character).
48