Second New Hardware Wizard Screen; Installing The Usbstyx Driver - Texas Instruments ADS131E08EVM-PDK User Manual

www.ti.com
2.3.2 Installing the Second USB Driver
Launch the ADS131E08EVM-PDK software from the program menu. The software loads and begins
downloading firmware to the processor on the MMB0. After the firmware is loaded and running, the Found
New Hardware Wizard starts again, as shown in
Click Next and the screen in
Click Next to complete the installation. If the computer is unable to find the USBStyx driver, point to the
installation directory of C:\Program Files\ADS131E08EVM\USB Drivers.
At this time, you may receive an error message because the ADS131E08EVM-PDK software has timed
out. If so, click OK, close the GUI program, power cycle the ADS131E08EVM, and restart the newly
installed ADS131E08 evaluation program. This process may need to be repeated if you plug the
ADS131E08EVM-PDK into a different USB port on your computer.
SBAU200C – June 2012 – Revised April 2020
Submit Documentation Feedback
Figure
Figure 10. Second New Hardware Wizard Screen
Figure 11 appears.
Figure 11. Installing the USBStyx Driver
Copyright © 2012–2020, Texas Instruments Incorporated
10.
Performance Demonstration Kit for the ADS131E08
Software Installation
9