Repair; Customer Service; Accessories; Spare Parts - ABON Ultra S Installation And Operating Instructions Manual

Repair

[55] Replace battery of hand-held
transmitter
• Pull off case lid (2) and remove it.
• Remove battery (1) and replace it.
Use leak proof batteries only. Ob-
serve correct polarity during inserting.
Dispose of old battery environmental-
friendly.
• Push case lid back in place.
[56] Replace glow lamp
Disconnect mains plug.
[57] Replace fuse
Disconnect mains plug.
• Remove or unscrew external connec-
tions like control lead (14) or antenna
(8).
• Loosen mounting screw (3).
• Snap off hood (4) at the four snap
pieces and remove it.
• Pull defective fuse (1) out of the fuse
holder (2) and replace it. Observe
fuse value!
• Push hood back in place.
• Tighten mounting screw.
• Re-establish external connections.
[30] Reset of electronic control
If the electronic control has to be reset,
proceed as follows:
• Push „Program" button (2) first, then
„Impulse" button (1) simultaneously
for longer than 5 seconds. The red
LED (3) flashes first and goes out af-
terwards – the reset is finished. The
drive lamp now starts flashing four
times and in this way indicates that
learning runs have to be carried out.
The learned run stretches for the
soft run and the threshold current for the
switching off due to excess force are de-
leted by the reset. The learned radio
commands remain saved.
• Carry out basic setting (learning
runs).

Customer Service

If you ask for help at any of the company
addresses on the back, please indicate
manufacturing number and model desig-
nation. You will find these data on the
type plate on the drive head.

Accessories

Western plugs are required for ex-
ternal connections on the drive head.
Accessories that can separately be or-
dered are listed as follows:
[58] 4-command hand-held transmitter
for multiple uses
[59] 1-command hand-held transmitter
[60] Wall mounting for hand-held trans-
mitter
[61] Wall-fit button
[62] Key turn button
[63] Code button
[64] External antenna
[65] Light barrier
[66] Optical sensor
[67] External emergency unlocking
device
[68] Internal emergency unlocking
device
[69] Safety strip

Spare parts

[70] See list of spare parts in installa-
tion scheme (image part).
Spare parts have to comply with techni-
cal requirements, which are defined by
the manufacturer. Only with original
spare parts this is always ensured.
In case of purchase orders the item
number has to be indicated.
Spare parts, which are marked
with „*", may be replaced by author-
ized specialists only.
Disposal
The national and local regulations and
statutes for disposal are to be followed.
Electric and electronic
parts have to be recy-
cled and are not to be
discarded in residen-
tial waste!
English
51