Assembling The Flywheel And Ignition Module; Assemble The Ignition Module - Husqvarna 545RXT AT Workshop Manual

Ignition system and heated handles
8.6 Assembling the flywheel and
ignition module
1. Inspect the key groove in the crankshaft for damage.
If it is damaged, replace the crankshaft (Reference).
See figure 9.
2. Inspect the key in the flywheel for damage. If it is
damaged,replace the flywheel. See figure 10.
3. Attach the flywheel and tighten the nut with the
correct torque. See service data

8.7 Assemble the ignition module

1. Position the ignition module on the crank case
2. Position the spacer between flywheel (see fig. 11
pos. A) and ignition module and press the ignition
module against the flywheel.
3. Tighten the bolts (B) and measure the air gap.
4. Position the ignition cable in the cable channel (C).
5. Install air guide plate. See figure 12 pos. A.
6. Install AT-cables on the air guide plate and connect
the cable to the AT-module . See figure 12 pos. B
and C.
7. Attach the air filter cover.
8. Attach the heat protector.
9. Connect spark plug cap. See fig 12 pos. D.
28 – English
Fig. 9
Fig. 10
Fig. 11
D
C
Fig. 12
C
B
B
A
A
B