Structure; Numbering; Tools; Symbols On The Product - Husqvarna 545RXT AT Workshop Manual

1.5 Structure

This workshop manual can be used as a guide for how to
repair a specific system on the product and for how to
dismantle and assemble the complete product.
To repair a specific system look up the page for the
system in question and follow the instructions.

1.6 Numbering

Position references to components in the figures are
designated A, B, etc. The figures are numbered 1, 2 etc.
The position references restart in each section. The
figure numbers restart in each chapter.

1.7 Tools

Special tools are required for some procedures. All
service tools are listed in the workshop manual and it is
clearly stated which tool to use in each section where it is
needed.
Always use Husqvarna original spare parts, service tools
and accessories.

1.8 Symbols on the product

Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual and make sure
that you understand the instructions before
you use this product.
Use protective helmet, approved hearing
protection and approved eye protection.
Always use approved protective gloves.
Use sturdy, non-slip boots.
Introduction and safety instructions
Purge bulb
Maximum speed of output shaft, rpm
Look out for thrown objects and ricochets.
Keep persons and animals at a minimum
distance of 15 meters during operation.
Risk of blade thrust. Keep persons and
animals at a minimum distance of 15 meters
during operation.
Start mode switch.
Refuelling.
Only use trimmer heads with trimmer cord
that is non-metallic and flexible, as cutting
attachment.
Air intake summer mode
Air intake winter mode
The product agrees with applicable EC
directives.
Noise emission to the environment
according to the European Community´s
Directive. The product´s emission is
specified in the Technical data chapter and
on the label.
Heated handle switch
English – 5