9.5 Dismantling
See figure 20.
Note: Do not remove the AT module from the carburettor.
1. Remove the 4 screws (A) that hold the metering
diaphragm cover and lift off the cover.
2. Carefully remove the metering diaphragm (C), spiral
support (D). and gaskets (B and E).
3. Inspect the diaphragm (C) for holes.
4. Inspect the spiral support (D) for wear. Especially
inspect the contact area for the metering lever.
5. Replace the diaphragm and the spiral support if
required.
B
C
D
E
Fig. 20
Carburettor
A
English – 35