Assembling - Husqvarna 545RXT AT Workshop Manual

Carburettor

9.6 Assembling

CAUTION: Make sure that the gasket surface is
clean from old gasket residue and dust.
See fig. 25.
CAUTION: During assembly the pump
diaphragm (B) shall be closest to the
carburettor housing. See figure 26.
1. Attach the throttle lever and springs.
2. Place the pump diaphragm (B) closest to the
carburettor housing. Put the gasket, cover and the
other components, back in the opposite sequence of
removal.
CAUTION: Tension the return spring (C) on
the shaft extension sufficiently. Otherwise
the pawl for the start throttle setting will not
work as intended.
38 – English
Fig. 25
A
B
Fig. 26