Inspection - Husqvarna 545RXT AT Workshop Manual

Crankshaft and crankcase

15.2 Inspection

1. The crankshaft cannot be reconditioned and must be
replaced if it is worn or damaged.
2. Inspect the large end of the connecting rod. If
seizure marks, discolouration on the sides or
damaged needle holders are found the crankshaft
must be replaced. See figure 4.
3. Inspect the small end of the connecting rod. See
figure 5.
4. If seizure marks or discolouration are found in the
bearing track the crankshaft must be replaced.
5. Inspect the crank bearing. Make sure that the
connecting rod does not have any radial play (up and
down) but that is has axial play. See figure 6.
6. Inspect the bearing and sealing for wear or damage
and replace if needed. See figure 7
Fig. 4
Fig. 5
Fig. 6
Fig. 7
English – 71