Ignition System - Husqvarna 131R Workshop Manual

7. Put the gasket (K) on the crankcase and attach the
screws (H) to the starter housing (J) and crankcase.
Attach screws (G) to the support plate and the
bracket (I). Attach the nuts (L) to the screws (G) and
tighten. Put the cylinder cover in the correct position
and attach the screws (F) to the starter housing and
cylinder cover. Tighten the screws to the correct
Service data for the model 967 84
torque. Refer to
31-xx and the model 967 84 30-xx on page 14 .
L
G
8. Attach the screw (D) to the cylinder cover (E). Attach
the spark plug cable (C). Attach the spark plug cap
(B) and the screw (A). Tighten all screws to the
correct torque. Refer to
967 84 31-xx and the model 967 84 30-xx on page
14
A
E
8.3.5 To replace the drive
1. Remove the starter assembly as given in
disassemble the starter on page 22 .
2. Use a piston stop to lock the axle.
24 - Repair instructions
K
J
F
I
H
Service data for the model
B
D
C
To
3. Loosen the nut (A). Remove the drive and the
spacer in the drive disc.
4. Examine the drive. Clean the drive if it is dirty.
Replace the drive if it is damaged.
5. Assemble in the opposite sequence to how it was
disassembled.

8.4 Ignition system

8.4.1 To disassemble the ignition system
1. Loosen the screws and remove the shaft assembly.
2. Remove the spark plug cover and the spark plug.
3. Remove the cylinder cover.
4. Remove the air filter cover.
A
675 - 002 - 23.04.2018