Assembling The Carburettor On The Engine Unit - Husqvarna 545RXT AT Workshop Manual

Carburettor
9.7 Assembling the carburettor on the
engine unit
1. Make sure that the spring is in its place in the start
switch (A).
2. Place the shaft extension into the start switch (B).
3. Place the carburettor in the filter house (C) and
activate the start switch. When the start switch is
activated it holds the carburettor and filter house
together. See figure 30.
4. Install the 2 screws at the bottom in the filter house
that holds the carburettor. See figure 31.
5. Connect the fuel hose to the carburettor (D). See
figure 32.
6. Connect the ignition module to the autotune (E). See
figure 32.
7. Make sure that the AT cable is inserted in the holders
(F) to avoid pinching.
8. Connect the fuel hose to air purge (G). See figure 33.
9. Connect the stop cable (H). See figure 33.
40 – English
A
Fig. 30
Fig. 31
F
Fig. 32
H
Fig. 33
B
C
E
D
G