Note: Do not use any sharp tools.
CAUTION: Tighten screws according to
service data.
21. Tighten the frame using M5*16 screws in the bottom
of the frame (A). See figure 42. For correct torque,
see service data.
22. Tighten the frame using M5*12 screws in the upper
part of the frame (B). See figure 42. For correct
torque, see service data.
23. Attach the cylinder cover (C) and the air filter cover
(F) and tighten the screws (E and D). See figure 42.
24. Make sure that the hooks in the rear part of the tank
cover is in the correct position on the tank unit when
pushing the cover into place. See figure 43.
Fig. 41
E
F
A
Fig. 42
Fig. 43
Carburettor
C
B
D
English – 43