Husqvarna 545RXT AT Workshop Manual page 42

Carburettor
14. Install the 2 upper screws that holds the housing
assembly and the filter holder. See figure 37.
15. Install the filter into the filter holder and attach the
clamps that hold the filter. See figure 38.
16. Make sure that full throttle is possible by giving full
throttle while controlling that the throttle stop hits the
stop. See fig. 39.
17. Activate the start switch.
18. Make sure the vibration support is not damaged and
in the correct place in the frame.
19. Install the frame on the engine body. Start from the
bottom, see figure 40. Make sure that the start switch
is in the correct position.
20. Use a tool to press down the vibration support on the
filter holder.
42 – English
Fig. 37
Fig. 38
Fig. 39
Fig. 40