Disassembly; Brush-Cleaning - Taylor Horizon 8752 Operator's Manual

6. When a steady stream of solution is flowing from the
prime plug hole in the bottom of the freezer door, pull
down the draw handle and draw off the remaining
cleaning solution.
7. Once the solution stops flowing from the door spout,
close the draw valve and press the WASH and
PUMP buttons to stop operation.
8. Repeat steps 1 through 7 for the other side of the
freezer on Model 8756.
Note: Place the power switch in the off position before
disassembling the machine.

Disassembly

WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. Check to make sure no lights are illuminated on the
control panel.
2. Remove the handscrews, freezer door, beater,
shoes, scraper blades, and driveshaft from the
freezing cylinder, and take them to the sink for
cleaning.
3. Remove the air line and the pressure line from their
connections.
4. Remove the check valve assembly from the pressure
switch cap.
5. Remove the pressure switch cap from the mix
cabinet and the remove the diaphragm.
6. Disassemble the check valve.
7. Remove the pressure relief valve and disassemble.
8. Repeat steps 2 through 7 for the other side of the
freezer on Model 8756.
9. Remove the front drip tray and splash shield.
Operating Procedures

Brush-Cleaning

1. Prepare a sink with an approved cleaning solution
(for example, Stera-Sheen ® ).
Note: Use warm water and follow the
manufacturer's specifications.
Important! Follow the label directions. Too strong of
a solution can cause parts damage, while too mild of
a solution will not provide adequate cleaning. Make
sure all brushes provided with the freezer are
available for brush cleaning.
2. Remove the seal(s) from the driveshaft(s).
3. From the freezer door(s) remove the gasket(s), front
bearing(s), pivot pin(s), draw handle(s), draw
valve(s), prime plug(s), and design cap(s).
4. Remove the flare line(s), suction line(s), air line(s)
pressure line(s), relief assembly(ies), and check
valve(s).
5. Disassemble all parts and remove the O-rings.
6. To remove O-rings, use a single-service towel to
grasp the O-ring. Apply pressure upwards until the 
O-ring pops out of its groove. With the other hand,
push the top of the O-ring forward. It will roll out of the
groove and can be easily removed. If there is more
than one O-ring to be removed, always remove the
rear O-ring first. This allows the O-ring to slide over
the forward rings without falling into the open
grooves.
7. Return to the freezer with a small amount of cleaning
solution. With the black bristle brush, brush-clean the
rear shell bearing(s) at the back of the freezing
cylinder(s).
Models 8752 and 8756 with Horizon® Pump
OPERATING PROCEDURES
Figure 6-56
6
10171
6-15