Malfunctions - SATA Paint set 10 Operating Instructions Manual

Operating Instructions SATA FDG
EN
Attention!
Damage from wrong cleaning agents
The use of aggressive cleaning agents can damage the material pres-
sure tank.
→ Do not use aggressive cleaning agents.
→ Use a neutral cleaning solution with a pH of 6–8.
→ Do not use acids, caustic solutions, bases, paint strippers, unsuitable
regenerates or other aggressive cleaning agents.
Attention!
Damage from solidified material
Solidified material in the material pressure tank can cause damage.
→ Remove the material from the material pressure tank at the latest
when the pot life has expired and clean the pressure tank.
■ Clean the material pressure tank every time after it has been used and
every time before changing the material.

13. Malfunctions

If it is not possible to remedy a malfunction with the described corrective
actions, send the material pressure tank to the SATA customer service
department (address see chapter 14).
Malfunction
Leak between
tank flange and
tank cover.
Leak in the com-
pressed air fitting.
Leak at the agitator
holder.
Leak at the material
outlet.
Material pressure
cannot be adjusted.
138
Cause
Tank flange, cover
seal soiled or porous.
Defective seals.
Defective seals.
Defective seals.
Material pressure
controller
defective.
Corrective action
Clean or replace the
seal.
Replace seals.
Replace seals.
Replace seals.
Replace material pres-
sure controller.