General Information - SATA Paint set 10 Operating Instructions Manual

Operating Instructions SATA FDG
EN
Read these operating instructions thoroughly and carefully before com-
missioning and use. Comply with the safety instructions and danger
warnings!
Always make sure that these operating instructions are kept with the
product or keep them easily accessible for everyone at any time!

1. General information

1.1. Introduction
These operating instructions contain important information for operating
the SATA paint set 10, SATA FDG 24 and SATA FDG 48, hereinafter ma-
terial pressure tank. They also describe commissioning, operation, main-
tenance and servicing, care and storage as well as troubleshooting.
1.2. Target group
This operating manual is intended for
■ Painting and varnishing professionals.
■ Trained personnel for varnishing work in industrial and craftman's work-
shops.
1.3. Accident prevention
As a basic principle, the general and specific national accident prevention
regulations must be heeded, together with corresponding workshop and
industrial safety instructions.
1.4. Replacement, accessory and wear-and-tear parts
In principle, only original replacement, accessory and wear-and-tear parts
from SATA are to be used. Accessories that were not delivered by SATA
are not tested and not approved. SATA assumes no liability whatsoever
for damages incurred due to the use of unapproved replacement, acces-
sory and wear-and-tear parts.
1.5. Warranty and liability
The SATA General Conditions of Sale and Delivery and further contractual
agreements, if applicable, as well as the valid legislation at the time apply.
SATA is not liable in case of
■ When the operating instructions are disregarded.
■ When the product is used in other than the intended ways of usage.
■ When untrained staff is employed.
■ When no personal protection equipment is worn.
124
Read first!