Right Cover - Canon imageFORMULA DR-C125 Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

2. Right Cover

1) Insert a tool with a thin flat end into the 5
pairs of fitting parts
and 2 each on the rear and bottom
marked with a symbol) in sequence to
spread open the gap, and then remove
the right cover
2
Note: Take care to avoid scratching the
cover with the tool. You should
unhook the rear and bottom fitting
parts first.
Figure 3-104
3-2
(1 on the front
1
.
COPYRIGHT © CANON ELECTRONICS INC. 2011
Note: Once you have removed the right
cover, the eject selection lever
and the door sensor lever on the base
side can be removed. Take care to
avoid accidentally
damaging it.
Figure 3-105
Notes on assembling
Ensure that you attached the door
sensor lever on the base side correctly.
After attaching the eject selection lever
to the cover, attach the cover. Ensure
that you align the positions of the fitting
parts on the eject selection lever and
flapper (straight or U-turn). There should
not be any gaps.
After assembling, check that the door
sensor lever and the eject selection
lever operate correctly.
1
dropping or
CANON DR-C125 FIRST EDITION