Canon imageFORMULA DR-C125 Service Manual page 77

3) Paper size is basically A4 size or LTR
size, and the above-mentioned shading
sheet, and must have the following
range: Width: 200 to 220 mm; Length:
130 to 297 mm.
4) To cause neither jams nor skews.
Example: Blacken the leading edge of a
A4 size or LTR size paper with a
black pen.
Use the sheet after the ink has dried.
Do not use a pencil.
The shading sheet may be used. Not
only one side, but also both sides
may be painted in black.
"A4 or LTR"
"Shading Sheet"
TKM-0326/0332
Figure 5-204
Note: If it stops in the middle when using
A4 size or LTR size paper due to the
computer specifications, set to half
the size. Note that you should cut
that paper perfectly straight without
any slant.
COPYRIGHT © CANON ELECTRONICS INC. 2011
Black region
2mm or more
Black region
2 to 4mm
CANON DR-C125 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Operation Procedure
1) Clean feed path, roller, and reading
glass.
2) Place a piece
adjustment sheet you prepared. Make
sure to set the document guides to fit the
sheet to prevent skews.
Note: The black edge
detected as the leading edge of the
sheet with the front side reading
sensor. Place the sheet so that the
black edge is the front and the
leading edge when fed. If both sides
have been filled with black, then
either side can be fed as the leading
edge. Do not place extra sheets.
Figure 5-205
3) On the service
[Registration Adjustment].
Figure 5-206
of the registration
needs to be
screen, select
5-5