Front Unit; Eject Pocket; Front Cover - Canon imageFORMULA DR-C125 Service Manual

II. FRONT UNIT

1. Eject Pocket

1) Remove the front unit.
(Page 3-4)
2) Open the eject pocket
horizontally to remove the shafts
both sides from the holes, and then
remove the eject pocket.
Figure 3-201
Note: Once you have removed the eject
pocket, U-turn roller (follower) can
also be removed. The U-turn roller
can be removed from the fitting parts
by pulling it out.
COPYRIGHT © CANON ELECTRONICS INC. 2011
CHAPTER 3 DISASSEMBLY & REASSEMBLY

2. Front Cover

1) Remove the front unit.
, slide it 2) Remove the eject pocket.
1
on
2
3) Use a tool to unhook the 10 pairs of
Note: Take care to avoid scratching the
Note: Once you have removed the front
CANON DR-C125 FIRST EDITION
(Page 3-4)
(Page 3-5)
fitting parts in sequence to spread
1
open the gap, and then remove the front
.
cover
2
cover with the tool. You should
unhook the bottom fitting part first.
Figure 3-202
cover, the button
support can be removed. Take
2
care to avoid accidentally dropping or
damaging it.
and eject
1
3-5