Canon Oce BLM550+ Operation Manual page 94

Jam in the Trim Area
Step
4
5
6
94 Chapter 6 - Error Conditions, Problems and Solutions
Action
Check the trim stop and remove any
pieces of trimmed paper.
Close the trim stop guard.
Attach the trim bin.
Information
In particular, check around the sensor.
The sensor is where you can see a red
and a green light (see illustration 'Loca-
tion of the sensor').
Small pieces of paper trimmings can
cover the sensor and cause an error
message.
Push the trim stop guard into position.
Hold the locking plates in position and
tighten the orange hand screws.