Table of Contents
Advertisement
Error Messages
Problem
SET IN GATHERING AREA
Shuttle axis moving
SHUTTLE MOTOR COMMS
FAIL
SHUTTLE MOTOR ERROR
SHUTTLE - No comms
SHUTTLE NOT PARKED
Sidelay axis moving
SIDELAY - No comms
STACKER FULL
82
Chapter 6 - Error Conditions, Problems and Solutions
Cause
There is a set or partial set in
the gathering area.
Open the gathering area and
remove the sheets.
If the print job has been can-
celed, open the gathering area
and remove the sheets. Or
touch START , then touch
ADVANCED > PURGE SET >
PURGE SET to clear the set
from the machine.
The shuttle axis is moving.
This message clears when the
adjustment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
The shuttle is in the wrong po-
sition. Touch START , then
follow the instructions on the
screen to reset the position.
The sidelay axis (size adjust-
ment) is adjusting. This mes-
sage clears when the adjust-
ment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
The stacker is full. Unload the
books from the stacker.
Solution
4
Advertisement
Table of Contents
