Plc Button - Devolo Magic2 LAN DINrail Manual

Ethernet (Fig. 2)
Ether- Flashing
net-LED viour
1 White Lights up steady
LED
2 White Flashes
LED
3 White Off
LED
*Information about the web interface can be
found in Chapter 5 Configuration.

2.3.4PLC button

devolo Magic adapters that are in factory default
condition, i.e. have been purchased or successfully
reset (see Chapter Resetting a devolo Magic ad-
apter or removing it from a devolo Magic net-
work), automatically start to attempt to pair with
another devolo Magic adapter when reconnected
to the mains supply.
beha- Meaning
Connection to the Ethernet network
Data transmission
Standby mode
Expanding an existing devolo Magic network
by adding another devolo Magic adapter
In order to use a new devolo Magic 2 LAN DINrail
in your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
devices as a network. This is accomplished by using
a shared password, which can be assigned in va-
rious ways:
b
Using devolo Cockpit
devolo Home Netwok App (see Chapter 4.2
Installation of devolo software)
devolo Magic 2 LAN DINrail
Introduction 18
LED status display
(web interface*)
Cannot be disabled
Cannot be disabled
Cannot be disabled
or the