Devolo Magic2 LAN DINrail Manual page 23

23 Elektrical installation
Single-phase connection without residual cur-
rent circuit breaker
Fig. 3
In
devolo Magic 2 LAN DINrail to one phase and
to one neutral conductor is adequate, even for
communicating over multiple phases. To opti-
mise the data transmission, however, we re-
commend a connection with all three-phases
and earth wire (PE).
devolo Magic 2 LAN DINrail
general, connection
Three-phase connection without residual cur-
rent circuit breaker
Fig. 4
of the
3
After installing the protective cover, the
devolo Magic 2 LAN DINrail can be connected
via Ethernet to the desired network device (e.g.
Internet router).
As soon as at least one other devolo Magic device
has been connected and plugged into the mains
supply, a PLC network is set up. For information on
how to proceed, refer to Chapter 4 Initial use.