Devolo Magic2 LAN DINrail Manual page 15

15 Introduction
PLC-LED
3 Red LED
4 Red and
white
LED
devolo Magic 2 LAN DINrail
Flashing be- Meaning
haviour
Lights up stea- Status 1:
dy The other network nodes are in standby
mode and cannot currently be accessed over
the mains supply. The PLC LEDs of the other
devolo Magic adapters flash white only for a
short time.
Status 2:
The connection to the other network nodes
has been interrupted. There may be electro-
magnetic or radio frequency interference on
the power line. In this case, put the
devolo Magic adapters closer to each other
or try to shut off the source of interference.
Red: flashes at Data transmission rate not in optimum
intervals of range
0.25 sec. on/
2 sec. off.
White: flashes
at intervals of
2 sec. on/
0.25 sec. off
LED status display
(web interface*)
Can be disabled
Can be disabled