Devolo Magic2 LAN DINrail Manual page 34

To do so, enter the desired new password twice.
Now the web interface is protected against un-
authorised access with your custom password!
Identify Device
The devolo Magic adapter can be located using the
Identify device function. Click Identify to make
the white PLC LED for the corresponding adapter
flash for 2 minutes to make it easier to identify by
sight.
LED
Enable the LED disabled option if the LEDs on the
devolo Magic adapter are intended to be switched
off for normal operation. An error status is indica-
ted by corresponding flashing behaviour regard-
less of this setting.
Powersaving
If Powersave mode has been enabled, the
devolo Magic 2 LAN DINrail switches to Powersave
mode automatically whenever reduced data trans-
mission over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
devolo Magic 2 LAN DINrail
Configuration 34