Connecting A Modem To The Sf/Cpu - Avaya 8800 Installation Manual

Module installation and connection
2. Insert the 9-pin receptacle end of the console cable into the console connector on
3. Attach the 9-pin plug end of the cable to the serial communications port on the back

Connecting a modem to the SF/CPU

Use an AT or Hayes-compatible modem and serial cable to provide remote dial-in access to
the CLI.
Procedure steps
1. Turn on and configure the modem using the parameters in the following table.
96 Installation — Modules
Parameter
Baud rate
Data bits
Stop bits
Parity
the 8692SF/CPU or 8895SF/CPU module.
of the PC or terminal.
See the modem documentation for instructions.
Setting
Clear to send (CTS) signal
Data terminal ready (DTR) signal
Data carrier detect (DCD) or
received line signal detection
(RLSD)
Data set ready (DSR) signal
Ready to send (RTS) signal
Synchronous/asynchronous mode Asynchronous
Auto answer
Local character echo
Supervisory functions
Baud rate
Comments? infodev@avaya.com
Value
9600
8
1
None
On
Modem can only connect if the DTR signal
is present. If the DTR signal is not present,
the modem disconnects.
On while the carrier is present. The switch
uses DCD to detect modem connect and
disconnect.
On
Ignored
Answer on two rings when DTR is active.
Off
Off
9600
Value
October 2014