Avaya 8800 Installation Manual page 65

8692 SF/CPU Ethernet management port
The Ethernet management port on the 8692SF/CPU module is a Medium Dependent Interface
(MDI) 10/100BASE-T port that allows out-of-band management of the switch using a Web
browser or Device Manager. You can also establish a Telnet or SSH (Secure Shell) session
to access the CLI. Use this port to connect the switch to a network management station. The
Ethernet management port has its own IP address, but does not switch traffic to other ports in
the chassis.
This port operates as a management port only. This port provides out-of-band management
for the 8692SF/CPU module.
8692 SF/CPU DCE/DTE switch
The DCE/DTE switch changes the pin assignments on the Console port. Use this switch to
designate the connector as either DTE or DCE. For information about pin assignments for the
Console port, see
8692 SF/CPU serial ports
The 8692SF/CPU module provides two serial ports for attaching modem and console devices.
The Console port provides CLI terminal access to the 8692SF/CPU module. Use the Modem
port to connect a standard modem for out-of-band, dial-up management. For information about
pin assignments for these ports, see
8692 SF/CPU Reset button
The recessed Reset button on the module performs a hard reset or reboot of the system. To
press the Reset button, insert a small object (for example, a paper clip) into the Reset button
hole.
8692 SF/CPU PCMCIA card slot
The PCMCIA memory card provides a convenient way to store switch configurations and boot
images. Use a memory card to quickly transfer configurations and images between switches
or store multiple configurations for a single switch.
Important:
For Release 5.0 and later, Avaya recommends that you use a PCMCIA card of not less than
256 MB storage capacity.
Installation — Modules
8692 SF/CPU modem port
8692 SF/CPU modem port
on page 115.
on page 115.
SF/CPU modules
October 2014 65