Specifying The Primary Sf/Cpu - Avaya 8800 Commissioning Manual

Initial steps using the CLI
Prerequisites
You must log on with the rwa credentials to use the command in this procedure.
Procedure steps
Configure the date and time by using the following command:
config setdate <MMddyyyyhhmmss>

Specifying the primary SF/CPU

Specify the primary SF/CPU to determine which SF/CPU you use as the primary after the
switch performs a full power cycle only. When the SF/CPU becomes the primary, the master
LED for the SF/CPU is on.
Procedure steps
1. View the current setting for the primary SF/CPU by using the following command:
2. Specify the slot of the primary SF/CPU by using the following command:
3. Save the configuration to the boot.cfg and pcmboot.cfg files.
4. Restart the switch.
Variable definitions
Use the data in the following table to use the config bootconfig master command.
<cpu-slot>
44 Commissioning
show bootconfig master
config bootconfig master <cpu-slot>
Variable Value
Specifies the slot number for the primary SF/
CPU. This variable can be 5 or 6. The default
primary is slot 5.
June 2011