SMART Podium ID422w Installation And User Manual page 6

iv
The Tethered Pen •
•
•
•
•
The Environment •
•
•
•
•
•
•
•
99-00724-00 REV C0
| – IM POR TA NT I NF O R MAT ION
The tethered pen is a sealed unit that contains electronics but no batteries. If you
attempt to open the tethered pen, you'll damage these electronics. This will make
the tethered pen unusable and void the warranty.
Don't touch the screen with any instrument other than the supplied pen because
other instruments may damage the screen's protective coating.
Don't use a pen that has worn down to a sharp or angular tip, as it may damage
the screen.
Don't apply excessive pressure that can shorten the life of the pen.
Don't immerse the pen in water.
Avoid setting up and using the interactive pen display in an area with excessive
levels of dust, humidity and smoke or where it's exposed to direct sunlight, severe
temperature changes, heat from other appliances, water or any other liquid.
Operate the interactive pen display within a temperature range of 41°F and 95°F
(5°C to 35°C) and a humidity range of 20% to 80% (non-condensing). However,
you can store the interactive pen display within a temperature range of 14°F to
140°F (-10°C to 60°C) and a humidity range of 20% to 90% (non-condensing).
Don't modify the power cord. Handle it carefully and avoid bending it excessively.
Don't place the power cord in an area where it's likely to be stepped on or pinched
by items placed on or against it. If you must run a cable over the floor, lay it in a
flat, straight line, and secure it to the floor with tape or a cable management strip
of contrasting color.
The interactive pen display comes with a three-prong, grounding-type power plug
(designed to fit into a grounding-type power outlet). If you can't insert the plug into
a power outlet, contact an electrician to replace the power outlet. Don't modify the
power plug.
Place the interactive pen display in a location where users will have clear and
direct access to the main power plug, as they must be able to disconnect the unit
at all times. Always disconnect the interactive pen display before you install any
devices or perform any maintenance.
If possible, disconnect the interactive pen display before any thunderstorms.
However, don't touch the unit or the unit's power plug during a thunderstorm, as
there is a risk of electrical shock.
Disconnect the interactive pen display if you won't use it for an extended period.
If the interactive pen display requires replacement parts, use parts that are
specified by SMART Technologies.
Don't expose the interactive pen display to rain or moisture.