Machine In Use With Direct Water Connection; Use Of The Machine; Preparation Of The Machine; Machine In Use With Water Tank - Profitec PRO 700 User Manual

Hide thumbs Also See for PRO 700:

User manual (33 pages)

Setup (2 pages)

Table Of Contents

Table of Contents

Available languages

10. Please consider that the procedure described in the steps above is the same if the steam/ hot water

boiler is deactivated: also in this case the steam/ hot water boiler will be filled and the PID display

indicates the temperature in the steam/ hot water boiler.

11. The machine is now ready for use.

Before preparing the first coffee, please clean the machine by extracting about 2L of hot

water from the brew group and the hot water wand.

5.2 Machine in use with direct water connection (steam/ hot water boiler activated)

1. Please make sure that the valve at the bottom panel of the machine and the switch behind the drip

tray are in the correct position (see chapter 4.3, image 1 and 2).

2. Make certain that the pump pressure gauge indicates enough pressure.

3. Plug the machine into an electrical outlet. Place the brew lever into the upper position.

4. Turn the machine on by placing the metal switch in the upper position. The green control lamp and the

PID display will come on and a pump noise will be heard. The coffee boiler and the steam/ hot water

boiler are now filled with water simultaneously.

As soon as water is released through the brew group, position the brew lever back downward. If there

is still a pump noise, the filling of the steam/ hot water boiler is still being completed.

Fill Modus (see chapter 5.1)

5. As soon as both boilers are filled with water, the pump will become quiet. The PID display and the

orange control lamp will illuminate. Both boilers are now being heated in succession whereby the

coffee boiler has priority.

6. Continue as described in chapter 5.1

The PRO 700 has a fuse to prevent the machine from overfilling.

It is possible that the machine does not heat up when using it for the first time or when

dispensing large quantities of water through the hot water valve. In this case, please

switch the machine off and on again.

Portafilter, drip tray, drip grid and water tank are not suitable for the dish washer .

6. USE OF THE MACHINE

6.1 Preparation of the machine

The switched off machine is to be placed into operation as follows:

6.1.1

Machine in use with water tank

Fill the water tank, if necessary.

2. Now turn the machine on (the metal switch in the upper position and the left switch behind the drip

3. To use the steam function, press the right switch behin

4. Please wait until the desired coffee-, i.e. steam temperature, has been reached (value indicated on the

PID-display). The machine is ready for steam/ hot water dispension as soon as the PID display

indicates the pre-set nominal temperature of 123°C (factory setting) or the boiler pressure gauge

indicates a value of about 1.0-1.5 bar. In general, the machine will be heated up in about 15 minutes,

depending on the ambient temperature.

The machine is now ready for use.

6.1.2