Troubleshooting - Profitec PRO 700 User Manual

•
Regulation (EC) No 1935/2004 regarding materials and objects intended to come into contact
with food
•
Regulation (EU) No 10/2011 on plastic materials and objects intended for the purpose of coming in
contact with food
•
Regulation (EC) No 2023/2006 on good manufacturing practice for materials and articles
intended to come into contact with food
For compliance, the following harmonized standards have been applied:
•
EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017
•
EN 60335-2-15:2016 + A11:2018
•
EN 55014-1:2017
•
EN 55014-2:2015
Note: In the event of any changes made to the devices mentioned above without our express permission,
this declaration of conformity will become invalid.

11. TROUBLESHOOTING

Problem
Little or no crema on the top
of the coffee
Little or no crema on top of
the coffee
Sparse coffee dispensing,
only drop by drop
Foam instead of crema
The machine is switched on,
but the machine does not
work.
Translation of the German original user manual
Possible Cause
The grind is not fine enough
The coffee is too old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground
coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee
grinder is not suited for the
coffee beans in use.
Water has been refilled; PID-
display is off
Troubleshooting
Use a finer grind.
Tamp the ground coffee more firmly.
Reduce the brewing pressure.
Use fresh coffee
Use the right coffee amount:
Approx. 7 g 9 g of coffee for each
cup.
Clean the brew group.
Set a coarser grind.
Tamp ground coffee only slightly.
Increase the brewing-pressure.
Use approx. 7 g 9 g of coffee for
every cup.
Set a finer grind..
Use fresh coffee.
Use approx. 7 g 9 g of coffee for
each cup.
Clean the shower screen.
Use another type of coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct position.
The side of the floater with the
magnet point must face towards
the inside of the machine. The
floater itself must be inserted with
the magnet point on the upper part
of the floater side.
ENGLISH
37