Programming The Cln Group Cleaning Mode - Profitec PRO 700 User Manual

8. Quickly press
the nominal temperature value.
9. Please wait a short while after having set the nominal temperature
10. Press 2 x in order to leave the programming mode. The newly
programmed nominal temperatures are now saved. Both heaters are
now activated successively.
6.2.2
You can also set whether the temperature values of t1 and t2 should be displayed in °C or °F.
To adjust this setting, proceed as follows:
+
1. Press and
2. Press the button
+
Press to enter the menu.
3. Now you can choose between C for Celsius and F for Fahrenheit by
pressing . This will also set t2.
4. Wait a short time and you will exit the menu automatically.
6.2.3

Programming the CLn group cleaning mode

With the PRO 700 you have the option to program a reminder for next the group cleaning at the PID
display. The machine is set to 0 at the time of delivery, so no reminder is programmed yet.
Please take the following steps to program the cleaning reminder:
+
Press and
the
Now you can carry out the programming in steps of 10 (0-200) by pressing
+
and .
appears and then press the
For example, if you have programmed 90, then you will be prompted with
Clean the brew group in such a manner that the brew group is flushed
with at least 10 brewing cycles until the temperature indication re-
appears on the display (see 7.2 Brew group cleaning).
We recommend a cleaning of the brew group after about 90 to 140 brewing cycles. As a
brew cycle only a brew over 15 seconds is counted.
Translation of the German original user manual
to decrease
+
to increase
twice. After t1, and t2, "o" appears on the display.
+
to enter the CLn menu.
button.
ENGLISH
31