Black Box mm146 User Manual page 75

Notes:
1. The table on the previous page provides regulatory safety information. It is not
intended to explain how to set up and use the product. Before making any connection
to the product please ensure that you have read and understood the contents of this
User Guide.
2. In terms of ensuring continued protection against electric shock, SELV (Safety
Extra-Low Voltage) status connections must only be interconnected to other apparatus
having SELV status ports.
3. As outlined in 2 (above) with the exception of the power supply plug and ethernet
connections, all connections made to this equipment must be SELV status.
4. The interconnection of ports of differing electrical safety status is likely to result in a
hazard and possible risk of electric shock.
5. If you have any doubt about the safety or suitability of other equipment to be
connected, please refer to a qualified electrical engineer.
Industry Canada ICES-003 / NMB-003
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
FCC Part 15 (USA)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
• Reorient the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that on which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply with Class B limits of Part 15 of
FCC Rules.
Technical Data
73