Black Box mm146 User Manual page 58

Using the Supervisor PIN Mode During a Call
56
You can change Far End preset if the following are true:
• The unit being called has Supervisor Mode turned ON.
• The unit being called has Remote Access turned ON.
• The correct Supervisor PIN is entered.
To set up video presets on a remote videophone:
menu button, then press the
Press the
1.
Manual Dial screen is displayed.
Use the number keys to enter the IP address in the Addr field of the party you
2.
wish to call.
Use the Down arrow key to highlight the PIN field. Use the number keys to
3.
enter the four digit Supervisor PIN.
Press the
4.
When the call is connected, press the
5.
arrow facing away from you indicates FAR end camera control. The
transparent S at the bottom left corner of the screen indicates Supervisor
Mode.
Press a number key between 1 and 3 to select the video source you wish to
6.
view.
Use the zoom in and
7.
pan/tilt/zoom the view you wish to save.
Press the round arrow center button twice followed by a number key, to save
8.
as your preset.
Repeat steps 7 to 9 as necessary.
9.
start button to dial your call.
zoom out buttons along with the arrow keys to
start button twice. The
source key. The transparent