Mounting Blank Panels - Fujitsu 1740 User Manual

4.6

Mounting Blank Panels

4.6.1 Confirming components
Confirm that all components have been delivered (see the table below).
Product name
1U blank panel
2U blank panel
3U blank panel
Also, prepare the necessary tools:
・Phillips screwdriver (No. 3 bit)
・Cage nut tool
4.6.2 Mounting blank panels
1
Attach cage nuts to the rack front left and right posts from the rear side.
The rack post has three square holes per height of 1U. According to the size of blank panel,
attach cage nuts to the following positions:
・ 1U: Two center holes on left and right
・ 2U: One center hole each at 1U and 2U, four in total on left and right
・ 3U: One center hole each at 1U and 3U, four in total on left and right
2
Secure the blank panel with M6 screws.
Secure the blank panels with screws through the holes corresponding to the cage nuts
attached in step 1.
'
134
Type name
19R-16BP1
19R-16BP2
19R-16BP3
The figure shows a general representation of 1U, 2U, and 3U blank panels. In
actual work, select and mount the appropriate size of blank panel according to the
available space.
Component and quantity
1U blank panel x 1, M6 cage nut x 2, M6 screw x 2
2U blank panel x 1, M6 cage nut x 4, M6 screw x 4
3U blank panel x 1, M6 cage nut x 4, M6 screw x 4