Mounting Stabilizers For Prevent Falling - Fujitsu PRIMERGY PG-R6RC1 User Manual

2.4

Mounting stabilizers for prevent falling

Mount the stabilizers to secure the rack to the installation site.
WARNING
The procedures for mounting the stabilizers are given below.
1
Install the rack, then secure in place by anchoring the feet.
→" Securing the rack" (pg.47)
2
Attach the stabilizers to the front/rear and right/left sides of the
rack.
3
Attach the stabilizers to the rack using three screws for front and
right/left sides, two screws for rear.
4
Secure to the ground.
1. The stabilizers on the front and rear sides are secured to the ground with two
screws (or bolts).
2. The stabilizers on the right and left sides are secured to the ground with three
screws (or bolts).
[Front]
The front and rear sides should be attached with two screws or bolts each,
while the other two sides should be attached with three screws or bolts each.
54
• Always use the stabilizers when installing the rack. If not secured in this fashion,
the rack may tip over when a unit is drawn out.
The rear and each side stabilizers are the options.
Screws or bolts for securing the stabilizers to the ground must be purchased
separately.
The rear and each side stabilizers are the options.
Securing with the screw
using three screws for front and right/left sides,
two screws for rear.