Changing The Position Of The Door Rotation Axis - Fujitsu 1740 User Manual

4.2

Changing the Position of the Door Rotation Axis

The position of the door rotation axis can be changed from the position at shipment. At the time of
shipment, the front door turns on the left axis, and the rear door turns on the right axis.
Changing the position of the rotation axis involves the repetitive action of removing parts and
reinstalling them at different locations. Work carefully to avoid causing deformation, breakage, or
loss of parts during the removal and reinstallation of parts.
Removed parts are all reused. No excess parts should be left over. Note that the
rack is supplied with no spare parts. Removing and installing some parts will
require certain degrees of strength. Work carefully.
General tools such as Phillips screwdrivers (No. 2 bit), standard screwdrivers, etc., are required for
the following operations.
4.2.1 Changing the position of the rotation axis of the front door
1
Remove the door from the rack.
Open the door, loosen the lower screws on each of the upper and lower hinge sets, and then
pull down the lower hinges. Use a Phillips screwdriver to loosen the screws.
Just loosen the screws. You do not need to remove them.
4 Handling the Rack after Installation
E
97