6
Attach the mounting fixtures and fully tighten the bolts securing the Quake
Proof Stabilizer kit components.
Secure the upper mounting fixture with four M12 bolts.
Note: Be careful when working at height on the top cover. Never put your foot on the rack
because it is very dangerous.
Attach the two lower mounting fixtures, one on the lower front and one on the lower rear of
the rack, each with two M8 bolts.
Use the M8 bolts used for the Quake Proof Stabilizer kit. If you are not using the Quake
Proof Stabilizer kit, use the bolts that come with the connection kit.
Note: When the Quake Proof Stabilizer kit components are attached, some of the M8 bolts of
the Quake Proof Stabilizer kit will not be required and, therefore, some of the bolts that
come with the connection kit will remain unused.
Fully tighten the bolts that were temporarily tightened.
'
M8 bolt
Upper mounting fixture
Lower mounting fixtur
M12 bolt
3 Rack Configuration and Installation
E
91