Tighten the retaining screws for the upper hinge set component while pressing
down on it in the direction of the lower hinge set component.
Loosen the retaining screws of the lower hinge set component and then lower the component
as far as it will go.
The retaining screws of the lower hinge set component will be fully tightened after the door is
mounted on the rack. For now, tighten it only temporarily.
'
Hinge retaining screw
View from the rear of the door
Lower hinge
Full tightening
set component
(Two locations: upper and lower)
Hinge set
4 Handling the Rack after Installation
E
113