Fujitsu 1740 User Manual page 107

4.2.2 Changing the position of the rotation axis of the rear door
1
Remove the door from the rack.
Open the door, loosen the lower screws on each of the upper and lower hinge set components,
and then lower the lower hinge set component. Use a Phillips screwdriver to loosen the
screws.
Just loosen the screws. You do not need to remove them.
2
Remove the M5 hexagon head screws, and then remove the stopper wire.
The removed screws and wire will be used later. Keep them in a safe and
convenient location.
Lift up the entire door to remove the door. Be careful not to get your fingers caught in the
gap between the door and rack.
'
Screw securing the lower hinge
(two locations: upper and lower)
Stopper wire
M5 hexagon head screw
Hinge set
Lower hinge
4 Handling the Rack after Installation
E
107