Fujitsu 1740 User Manual page 112

7
Install the door handle and rods.
Before starting this work, turn the door upside down.
Insert the assembly of the door handle and rods from the front of the door in such a way that
the upper (short) rod will be on top.
Secure the door handle with the M5 screws.
Secure the upper and lower rods with the rod supporters.
'
after installation)
(Upper and lower supporters)
8
Attach the stopper wire to the door and adjust the upper and lower hinge
set component positions.
Attach the stopper wire to the door and temporarily tighten the M5 hexagon head screw. This
screw will be fully tightened when the wire is attached to the rack.
Adjust the hinge positions. (The upper hinge set component has been left loose since the
door was removed.) Lower the upper hinge set component as far as it will go and then
tighten the retaining screw. Fully tighten the screw while taking care not to tilt the hinge.
112
Upper rod (short)
Lower rod (long)
Upper rod (short)
Rod supporter
(Normal state
Door handle
M5 screw
Door
Door handle