10.2.2
Priming Instructions for Freezers Built into a Wall
1. Place a bucket under the dispense
head. Remove the actuator rod from the
spigot. Leave spigot open. (figure 10-4)
2. Fill mix hopper with one gallon of mix
and allow mix to push out remaining
sanitizer. When pure mix is flowing from the
dispense head close the dispense handle
(figure 10-4). Reinstall the actuator rod.
Failure to completely remove sanitizer
or water from the freezing cylinder
before placing in
damage the freezer.
3. Press the
the freezer..
4. Repeat Steps 1 - 3 for the other side of
the freezer.
5. Sanitize and install nozzles.
Figure 10-5 "OPEN" — position
184584
ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
Important:
freeze will
freeze button to start
"OPEN"
READY TO SERVE
Figure 10-6 "CLOSED" — position
"CLOSED"-
FILL
WITH MIX
31