Priming; Standard Priming Insturctions - ELECTRO FREEZE SLX400 Operator's Manual With Replacement Parts List

ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
10.2

Priming

MIX INLET PORT
Figure 10-3 Mix Feed Tube Assembly
10.2.1 Standard Priming Instructions
head.
one gallon of mix open the plunger by
pulling the dispense handle down and allow
mix to push out remaining sanitizer. When
pure mix is flowing from the dispense head
close the dispense handle (figure 10-4).
Failure to completely remove sanitizer or
water from the freezing cylinder before
placing in
freezer.
30
MIX FEED
TUBE
O RING
1. Place a bucket under the dispense
2. While filling the mix hopper with
Important:
freeze will damage the
Priming the freezer removes all excess
sanitizer from the freezing cylinder, and sets
the proper overrun for the first cylinder of
product.
1. Make sure that your hands, fore-
arms, and all freezer assemblies are
REGULATOR
sanitized.
2. See figure 10-3. Insert the regulator
into the mix feed tube assembly. Place mix
feed tube on sanitized surface. Set to
desired port size number. Larger holes are
for thicker products. Insert the mix feed tube
assembly into the hopper drain outlet.
3. Proceed to instructions in section
10.2.1 or 10.2.2 depending on freezer setup.
3. Allow mix to continue flowing into
the cylinder until the mix in the hopper stops
bubbling. Insert mix feed tube assembly.
4. Press the
the freezer.
5. Repeat Steps 1 - 4 for the other side
of the freezer.
6. Sanitize and install nozzles.
Figure 10-4 Pure mix
freeze button to start
184584