ELECTRO FREEZE SLX400 Operator's Manual With Replacement Parts List page 32

ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
8.3 Cleaning Instructions
Figure 8-7
Figure 8-8
Figure 8-9
Replace worn brushes. Use
24
Clean shaft seal, washer, plunger,
and nozzle
Clean beater shaft
Clean hopper and mix
feed port
only Electro Freeze original
or authorized replacement
parts.
(continued)
3. Rinse parts with clear water and
place in sanitizing solution for 5 minutes.
Do not leave parts in sanitizer for
more than 15 minutes.
4. Place parts on a clean surface and
allow to air dry
5. Using a warm mild dish detergent
thoroughly brush:
a. the hoppers and the mix feed
tubes from the hopper to the cylinders.
(figure 8-9).
b. the inside of the cylinders
making certain to clean the back walls with
4" diameter brush provided.
c. the inside of the drain tube
(figure 8-10). Dip the brush in the dish
detergent solution and force brush into
the drain tube until it stops - repeat until
clean.
6. Repeat step 5 using a brush to
rinse with water and then brush with sanitiz-
ing solution.
7. Remove the drip tray and insert.
Wash in a warm dish detergent solution,
rinse with clear water and place in santizing
solution for 5 minutes.
8. Wash the outside of the freezer and
inside of the cabinet with a warm dish
detergent solution. Rinse with water
Figure 8-10 Clean inside of drain tube
Important:
184584