Assembly - ELECTRO FREEZE SLX400 Operator's Manual With Replacement Parts List

9

Assembly

Figure 9-1
Figure 9-2
Figure 9-3
184584
ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
Lubricate shaft seal
Assemble beater shaft
assembly
Lubricate bearing areas of
breaker bar
Correct assembly of the freezer is essential
to prevent leakage of the product and
damage to the freezer. To assemble the
freezer you will need an approved lubricant,
such as Petrol Gel. Make sure all parts of
the assemblies have been washed and
sanitized before assembling. Follow these
directions for each cylinder of the freezer.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad is
"OFF" and that the power
switch is "OFF".
1. Persons assembling the freezer
must first wash and sanitize their hands and
forearms with an approved sanitizer.
2. To assemble the shaft seal, install
the cup seals on the plastic washer as
shown in figure 9-1.
3. Apply a moderate amount of
approved sanitary lubricant (such as Petrol
Gel) to the beater shaft as shown in figure
9-2. Install the shaft seal over the rear of the
beater shaft, (figure 9-2). Do not allow any
lubricant to come in contact with the bell-
shaped rubber portions of the shaft seal.
4. Apply lubricant to the bearing areas
of the breaker bar (figure 9-3).
5. Place the scaper blades on the
beater shaft, making sure the blades are
installed properly.
6. Slide the breaker bar into the
center of the beater shaft, making sure the
bar fits into the hole in the rear beater shaft
disc (figure 9-2).
7. Insert the assembled beater shaft
into the cylinder by placing the rear blade
on the bottom of the cylinder. This will
center the beater shaft and allow alignment
with the drive coupling. Rotate the beater
assembly while pushing, until the shank
has engaged the coupling. Install both
beater shafts.
— continued
BLADE-SCRAPER
25