ELECTRO FREEZE SLX400 Operator's Manual With Replacement Parts List page 34

ELECTRO FREEZE Soft Serve Models SLX400, SLX400E, SLX500
9 Assembly
Figure 9-4
figure 9-4) (see O-ring Chart - Replacement
Parts Manual) on the dispensing plungers
(4,5) and insert half-way into the head (1).
head O-rings (2) .
assembly by placing the 2 shorter handles
(9) on the sides and the longest handle (10)
in the center. Lock in place with the handle
pin (7).
Excessive force will damage the head. Do
not use tools to tighten.
26
(continued)
Note: Item 10 center handle is longer.
Head Assembly
8. Install and lubricate the O-rings (4,
9. Install and lubricate the two 4-inch
10. Position the handles in the head
Important:
11. Install the dispensing head onto the
freezer by aligning the studs with the holes
in the head and sliding toward the freezer.
Tighten hand knobs evenly, finger-tight only.
12. Install the plunger rods (6). The
nozzles (11) will be installed on the mix
outlet at the bottom of the head after
sanitizing.
13. Install the o-rings (3) on the mix
feed tube (1). Lightly lubicate the o-rings as
shown in figure 9-5.
— continued
184584