Table of Contents
Advertisement
MSI-8000 RF Remote Display
4.0
Setup
This section provides an overview of the MSI-8000 RF Remote Display setup instructions.
4.1
Setup Navigation
To navigate the menus during setup, follow the information below:
• Press
to enter or select a parameter
F1
• Press
to scroll through the parameters
F2
• To enter a decimal point, press
to save and go back one level or to Weigh mode; displays briefly
• Press
ZERO
• If a wrong value is entered, press
• Press
to exit without saving changes
POWER
4.2
Setup Menu
To enter the setup menu, press
Parameters
Choices
Function Key 1 – Configurable to listed parameters
–
Function Key 2 – Configurable to listed parameters
No function is assigned; The F-key is disabled
Test – Runs an LCD test
Total – Accumulates multiple weighments
View Total – Activates the total weight display followed by the number of samples
Net/Gross – Toggles between Net and Gross modes
Peak Hold – Automatically updates display when a higher peak weight reading is established
2 Units – Switches the force units between lb and kg
5 Units – Scrolls through all available units: lb, kg, Tons (US Short), metric tons and kilonewtons
Hi Res – The unit is more sensitive to motion and movement resulting in a less stable display
Print – Outputs a configured text string to the RS-232 port on the base of the Dyna-Link
Tare – Not used, MSI-8000 RF Remote Display has a dedicated Tare key
Scan – Displays RF connected channels in order
Total Remote Devices – Displays the summed weight of RF connected sensors
Auto Off – Prolongs battery life of the scale by turning power off after the set time (in minutes) that the scale is not in use
(Section 4.4 on page
Greater Than – Setpoint triggers when the tension exceeds the value
Less Than – Setpoint triggers when the tension is less than the value
Off - Setpoint parameter is disabled
Battery Life – Sets the options for standard or extended battery life
Standards – Sets the industry standard to be used
www.RiceLake.com
8
Visit our website
while the digit is blinking
POWER
to step back one digit and press
ZERO
and
simultaneously.
F3
PRINT
ZERO
(Section 4.3.1 on page
(Section 4.3.2 on page
11)
Table 4-1. Setup Menu Parameter Descriptions
to change the digit
F2
Description
(Section 4.3 on page
9); Default
(Section 4.3 on page
9); Default
9)
9)
(Section 4.3.2 on page
(Section 4.3.3 on page
10)
(Section 4.3.5 on page
10)
(Section 4.3.8 on page
(Section 4.6 on page
9)
(Section 4.3.4 on page
10)
(Section 4.3.5 on page
10)
(Section 4.3.6 on page
10)
(Section 4.3.7 on page
11)
11)
13)
Advertisement
Table of Contents
